Radius Server Key; Radius Server Msgauth - Dell Force10 S2410-01-10GE-24P Command Reference Manual

radius server key

Configure the shared secret between the RADIUS client and the RADIUS accounting / authentication
server.
radius server key {auth | acct} ipaddr
Syntax
Depending on whether the auth or acct keyword is used, the shared secret will be configured for the
RADIUS authentication or RADIUS accounting server. The IP address provided must match a
previously configured server. When this command is executed, the secret will be prompted. The secret
must be an alphanumeric value not exceeding 16 characters.
Mode Global Config

radius server msgauth

This command enables the message authenticator attribute for a specified server.
radius server msgauth ipaddr
Syntax
Mode Global Config
radius server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS client.
The primary server is the one that is used by default for handling RADIUS requests. The remaining
configured servers are only used if the primary server cannot be reached. A maximum of three servers
can be configured on each client. Only one of these servers can be configured as the primary. If a
primary server is already configured prior to this command being executed, the server specified by the
IP address specified used in this command will become the new primary server. The IP address must
match that of a previously configured RADIUS authentication server.
radius server primary ipaddr
Syntax
Mode
Global Config
radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted when no response
is received from the RADIUS server. The retries value is an integer in the range of 1 to 15.
The no version of this command sets the maximum number of times a request packet is re-transmitted,
when no response is received from the RADIUS server, to the default value, i.e. 10.
radius server retransmit retries
Syntax
no radius server retransmit
Security Commands | 201