Show Ip Interface - Dell Force10 S2410-01-10GE-24P Command Reference Manual

routing
This command enables routing for the selected interface.
[no] routing
Syntax
The no version of this command disables routing for an interface. The current value for this function is
displayed under show ip interface labeled as "Routing Mode".
Default disabled
Mode
Interface Config
Related

show ip interface

Commands
interface
show ip interface
This command displays summary information about IP configuration settings for all ports in the router.
This command takes no options.
show ip interface {brief | unit/slot/port | vlan 1-3965 }
Syntax
Mode Privileged Exec, User Exec
Example 1 Figure 22-129. show ip interface brief output Command Example
(Force10) #show ip interface brief
Interface IP Address
--------- --------------- --------------- -------- --------
1/0/3
Report Fields
(see below)
10.0.0.2
Interface—Valid unit, slot, and port number separated by forward slashes
IP Address—The IP address of the routing interface in 32-bit dotted decimal format
IP Mask—The IP mask of the routing interface in 32-bit dotted decimal format
Netdir Bcast—Indicates if IP forwards net-directed broadcasts on this interface. Possible
values are Enable or Disable.
MultiCast Fwd—Indicates the multicast forwarding administrative mode on the interface.
Possible values are Enable or Disable.
Sets the IP gateway of the switch.
Invokes the Interface ManagementEthernet mode, the
(Config-if-ma)# prompt.
Netdir
IP Mask Bcast
255.255.255.0 Disable
Multi
CastFwd
Disable
Routing Commands | 401