Ip Access-Group (Interface) - Dell Force10 S2410-01-10GE-24P Command Reference Manual

log
assign-queue
queue-id
{
unit/slot/port
Default none
Mode Global Config
Command
Version 2.5.1
History
Related
{deny|permit}
Commands
interface loopback

ip access-group (Interface)

show ip access-lists
show interface loopback
ip access-group (Interface)
This command attaches a specified IP access-control list (ACL) to an interface.
ip access-group ACLnumber [ 1-4294967295 ] in
Syntax
Parameters
ACLnumber
1-4294967295
in
Default
none
(OPTIONAL) Specifies that hits on this rule are to be logged (For details, see the
System Logs chapter in the SFTOS Configuration Guide). The
only for
(OPTIONAL) The assign-queue ID is the queue identifier to which packets
matching this rule are assigned.
mirror redirect
| } (OPTIONAL) Specify whether the packets matching this rule are mirrored or
redirected through the specified port. A redirected packet carries the same MAC
address as it would have if it had not been redirected (the MAC address of the
next hop defined in the routing table).
Note:
The mirror option is supported in the S50V and S25P models only; it is
not available on S50 switches, nor for extended access lists (100–199).
Source, destination, and monitor/redirect ports must be in the same
VLAN.
Enter the ACL ID, which is an integer with a range of 1–199 assigned using the
OOEnn6ganC
(OPTIONAL) Enter an integer that indicates the order of this ACL relative to
other ACLs assigned to this port channel. A lower sequence number indicates
higher precedence order. If the selected number is already in use for this port
channel, this ACL replaces the currently attached ACL using that sequence
number. If you do not specify a number with this command, a number that is one
greater than the highest sequence number currently in use for this port channel is
used for this ACL.
The in parameter is required. SFTOS supports only the ingress direction.
deny
rules.
These options are only for a permit rule.
log
Modified to include and
Creates a new rule for the current MAC access list.
Configures a loopback interface.
Attaches a specified ACL to the selected interface.
Displays an IP Access Control List (ACL) and all of the rules that are defined
for the ACL.
Displays loopback interface configuration.
command
mirror
options.
ACL Commands | 381
log
attribute is