Primary Fwsm Configuration (Example 7 - Cisco 7604 Configuration Manual

Appendix B Sample Configurations
Figure B-7
VLANs 200-202
See the following sections for the configurations for this scenario:
•
•
•

Primary FWSM Configuration (Example 7)

The following sections include the configuration for the primary FWSM:
•
•
•
•
System Configuration (Primary Unit—Example 7)
You must first enable multiple context mode using the mode multiple command. Then enter the
activation key to allow more than two contexts using the activation-key command. The mode and the
activation key are not stored in the configuration file, even though they do endure reboots. If you view
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Example 7
Active Switch
MSFC
HSRP IPs:
10.0. n .4
Primary
FWSM
Mgmt IPs:
10.0.3.1
10.0.1.1
10.0.2.1
VLAN 4
VLAN 5
VLAN 6
Primary FWSM Configuration (Example 7), page B-23
Secondary FWSM System Configuration (Example 7), page B-26
Switch Configuration (Example 7), page B-26
System Configuration (Primary Unit—Example 7), page B-23
Context A Configuration (Primary Unit—Example 7), page B-24
Context B Configuration (Primary Unit—Example 7), page B-25
Context C Configuration (Primary Unit—Example 7), page B-25
Internet
VLAN 100
Standby Switch
Failover Links:
VLAN 10
Trunk:
VLANs 10 and 11
VLAN 11
Mgmt IPs:
10.0.3.2
Context A
Context B
Context C
Failover Example Configurations
MSFC
HSRP IPs:
10.0. n .4
Secondary
FWSM
10.0.1.2
10.0.2.2
B-23