Cisco 7604 Configuration Manual page 292

Configuring Failover
Table 14-5
Field
Stateful Failover Logical
Update Statistics
Link
Stateful Obj
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
14-38
Show Failover Display Description (continued)
Options
The following fields relate to the Stateful Failover feature. If the Link
field shows an interface name, the Stateful Failover statistics are shown.
•
•
•
•
•
For each field type, the following statistics are used. They are counters
for the number of state information packets sent between the two units;
the fields do not necessarily show active connections through the unit.
•
•
•
•
General Sum of all stateful objects.
sys cmd Logical update system commands; for example, LOGIN and Stay
Alive.
up time Up time, which the active unit passes to the standby unit.
RPC services Remote Procedure Call connection information.
TCP conn TCP connection information.
UDP conn Dynamic UDP connection information.
ARP tbl Dynamic ARP table information.
L2BRIDGE tbl Layer 2 bridge table information (transparent firewall mode only).
Xlate_Timeout Indicates connection translation timeout information.
VPN IKE upd IKE connection information.
VPN IPSEC upd IPSec connection information.
VPN CTCP upd cTCP tunnel connection information.
VPN SDI upd SDI AAA connection information.
VPN DHCP upd Tunneled DHCP connection information.
GTP PDP GTP PDP update information. This information appears only if inspect
GTP is enabled.
GTP PDPMCB GTP PDPMCB update information. This information appears only if
inspect GTP is enabled.
interface_name—The interface used for the Stateful Failover link.
Unconfigured—You are not using Stateful Failover.
up—The interface is up and functioning.
down—The interface is either administratively shutdown or is
physically down.
failed—The interface has failed and is not passing stateful data.
xmit—Number of transmitted packets to the other unit
xerr—Number of errors that occurred while transmitting packets to
the other unit
rcv—Number of received packets
rerr—Number of errors that occurred while receiving packets from
the other unit
Chapter 14 Configuring Failover
OL-20748-01