Cisco 7604 Configuration Manual page 82

Catalyst 6500 series switch and cisco 7600 series router firewall services module configuration guide using the cli

Hide thumbs Also See for 7604:

Table of Contents

Managing Memory for Rules

For example, if you have 4 partitions, and you want to reduce partitions 0 and 1 to 40000, while

increasing partitions 2 and 3 to 56616 and 56615 respectively, enter the following commands:

hostname(config)# show resource partition

-----------+---------+----------+-----------

-----------+---------+----------+-----------

Total Partition size - Configured size = Available to allocate

hostname(config)# resource partition 0

hostname(config-partition)# size 40000

hostname(config-partition)# resource partition 1

hostname(config-partition)# size 40000

hostname(config-partition)# show resource partition

-----------+---------+----------+-----------

-----------+---------+----------+-----------

Total Partition size - Configured size = Available to allocate

hostname(config-partition)# resource partition 2

hostname(config-partition)# size 56616

hostname(config-partition)# resource partition 3

hostname(config-partition)# size 56615

hostname(config-partition)# show resource partition

Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM

If you add a secondary unit at a later date, then after the new secondary unit synchronizes the

configuration, immediately reload the secondary unit so that the memory partitions are the same.

During the initial synchronization, the configuration might not fit properly in the secondary unit

memory partitions, but after reloading, and another configuration synchronization, the

secondary unit will be operational.

Configuring Security Contexts

Show Quick Links

Table of Contents

Troubleshooting