Cisco 7604 Configuration Manual page 291

Chapter 14 Configuring Failover
Table 14-5
Field
Failover
Failover Unit
Failover LAN Interface
Unit Poll frequency
Interface Poll frequency
Interface Policy
Monitored Interfaces
Group 1 Last Failover at:
Group 2 Last Failover at:
This host:
Other host:
Role
System State
Group 1 State
Group 2 State
context Interface name
(n.n.n.n):
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Xlate_Timeout 0
GTP PDP 0
GTP PDPMCB 0
Show Failover Display Description
Options
•
•
Primary or Secondary.
Displays the name of the failover link.
Displays the number of seconds between hello messages sent to the
peer unit and the number of seconds during which the unit must receive
a hello message on the failover link before declaring the peer failed.
n seconds
The number of seconds you set with the failover polltime interface
command. The default is 15 seconds.
Displays the number or percentage of interfaces that must fail before
triggering failover.
Displays the number of interfaces monitored out of the maximum
possible.
The date and time of the last failover for each group in the following
form:
hh:mm:ss UTC DayName Month Day yyyy
UTC (Coordinated Universal Time) is equivalent to GMT (Greenwich
Mean Time).
For each host, the display shows the following information.
Primary or Secondary
•
•
•
•
For each interface, the display shows the IP address currently being
used on each unit, as well as one of the following conditions:
•
•
•
•
•
•
0 0
0 0
0 0
On
Off
Active or Standby Ready
Active Time in seconds
Active or Standby Ready
Active Time in seconds
Failed—The interface has failed.
No link—The interface line protocol is down.
Normal—The interface is working correctly.
Link Down—The interface has been administratively shut down.
Unknown—FWSM cannot determine the status of the interface.
Waiting—Monitoring of the network interface on the other unit has
not yet started.
Configuring Failover
0
0
0
14-37