Cisco 7604 Configuration Manual page 287

Chapter 14 Configuring Failover
Stateful Failover Logical Update Statistics
Table 14-4
Field
Failover
Failover Unit
Failover LAN Interface
Unit Poll frequency
Interface Poll frequency
Interface Policy
Monitored Interfaces
failover replication http
Last Failover at:
This host:
Other host:
Primary or Secondary
Active time:
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Status: Configured.
Stateful Obj xmit
RPC services 0
TCP conn 99
UDP conn 0
ARP tbl 22
Xlate_Timeout 0
GTP PDP 0
GTP PDPMCB 0
Show Failover Display Description
Options
•
•
Primary or Secondary.
Displays the name of the failover link.
Displays the number of seconds between hello messages sent to the
peer unit and the number of seconds during which the unit must receive
a hello message on the failover link before declaring the peer failed.
n seconds
The number of seconds you set with the failover polltime interface
command. The default is 15 seconds.
Displays the number or percentage of interfaces that must fail to trigger
failover.
Displays the number of interfaces monitored out of the maximum
possible.
Displays if HTTP state replication is enabled for Stateful Failover.
The date and time of the last failover in the following form:
hh:mm:ss UTC DayName Month Day yyyy
UTC (Coordinated Universal Time) is equivalent to GMT (Greenwich
Mean Time).
For each host, the display shows the following information.
•
•
n (sec)
The amount of time the unit has been active. This time is cumulative,
so the standby unit, if it was active in the past, will also show a value.
xerr rcv
0 0
0 0
0 0
0 0
0 0
0 0
0 0
On
Off
Active
Standby
Configuring Failover
rerr
0
0
0
0
0
0
0
14-33