System Configuration (Example 3 - Cisco 7604 Configuration Manual

Appendix B Sample Configurations
Figure B-3
Config Server
See the following sections for the configurations for this scenario:
•
•
•
•
•

System Configuration (Example 3)

You must first enable multiple context mode using the mode multiple command. Then enter the
activation key to allow more than two contexts using the activation-key command. The mode and the
activation key are not stored in the configuration file, even though they endure reboots. If you view the
configuration on the FWSM using the write terminal, show startup-config, or show running-config
commands, the mode displays after the FWSM Release (blank means single mode, "<system>" means
you are in multiple mode in the system configuration, and <context> means you are in multiple mode in
a context).
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Example 3
Outside
209.165.201.3
Admin
Context
Inside Shared
10.1.0.1 10.1.1.1
VLAN 201
Admin Host
10.1.0.16 10.1.0.15
VLAN 300
System Configuration (Example 3), page B-9
Admin Context Configuration (Example 3), page B-10
Department 1 Context Configuration (Example 3), page B-11
Department 2 Context Configuration (Example 3), page B-12
Switch Configuration (Example 3), page B-12
Internet
MSFC
209.165.201.2
VLAN 200
Outside
209.165.201.4
Department 1
Inside Shared
10.1.2.1 10.1.1.2
VLAN 202
VLAN 300
Web Server
10.1.2.3
AAA Server Mail Server
10.1.1.6 10.1.1.7
Routed Mode Sample Configurations
Outside
209.165.201.5
Department 2
Inside Shared
10.1.3.1 10.1.1.3
VLAN 203
Inside
VLAN 300
Shared
Network
Syslog Server
10.1.1.8
B-9