Configuring Pim Message Intervals; For More Information About Multicast Routing - Cisco 7604 Configuration Manual

For More Information About Multicast Routing

hostname(config)# pim accept-register {list acl | route-map map-name}

Configuring PIM Message Intervals

Router query messages are used to elect the PIM DR. The PIM DR is responsible for sending router
query messages. By default, router query messages are sent every 30 seconds. You can change this value
by entering the following command:
hostname(config-if)# pim hello-interval seconds
Valid values for the seconds argument range from 1 to 3600 seconds.
Every 60 seconds, the FWSM sends PIM join/prune messages. To change this value, enter the following
command:
hostname(config-if)# pim join-prune-interval seconds
Valid values for the seconds argument range from 10 to 600 seconds.
For More Information About Multicast Routing
The following RFCs from the IETF provide technical details about the IGMP and multicast routing
standards used for implementing the SMR feature:
•
•
•
•
•
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
9-8
RFC 2236 IGMPv2
RFC 2362 PIM-SM
RFC 2588 IP Multicast and Firewalls
RFC 2113 IP Router Alert Option
IETF draft-ietf-idmr-igmp-proxy-01.txt
Chapter 9 Configuring Multicast Routing
OL-20748-01