Ipv6-Enabled Commands - Cisco 7604 Configuration Manual

Configuring IPv6
This chapter describes how to enable and configure IPv6 on FWSM. IPv6 is available in routed firewall
mode only.
This chapter includes the following sections:
•
•
•
•
•
•
•
•
•
For an example IPv6 configuration, see the
page

IPv6-Enabled Commands

The following FWSM commands can accept and display IPv6 addresses:
•
•
•
•
•
•
•
•
•
•
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
IPv6-Enabled Commands, page 10-1
Configuring IPv6 on an Interface, page 10-2
Configuring a Dual IP Stack on an Interface, page 10-4
Configuring IPv6 Duplicate Address Detection, page 10-4
Configuring IPv6 Default and Static Routes, page 10-5
Configuring IPv6 Access Lists, page 10-5
Configuring IPv6 Neighbor Discovery, page 10-6
Configuring a Static IPv6 Neighbor, page 10-10
Verifying the IPv6 Configuration, page 10-10
B-13.
capture
configure
copy
http
name
object-group
ping
show conn
show local-host
show tcpstat
C H A P T E R
"Example 4: IPv6 Configuration Example" section on
10
10-1