Disabling Logging To All Configured Output Destinations; Viewing The Log Configuration; Printing Of Mapped Names Of Hosts Or Networks - Cisco 7604 Configuration Manual

Chapter 25 Monitoring the Firewall Services Module
For more information about configuring log output destinations, see the
Destinations" section on page
To enable logging, enter the following command:
hostname(config)# logging enable

Disabling Logging to All Configured Output Destinations

To disable all logging to all configured log output destinations, enter the following command:
hostname(config)# no logging enable

Viewing the Log Configuration

To view the running log configuration, enter the following command:
hostname(config)# show logging
The following is sample output of the show logging command:
Syslog logging: enabled

Printing of Mapped Names of Hosts or Networks

To enable printing of mapped names of hosts or networks in syslog messages, enter the following
command:
hostname(config)# logging names
To print IP addresses instead of mapped names of hosts or networks in syslog messages, enter the
following command:
hostname(config)# no logging names
The following example shows how to display syslog messages with mapped names of IP addresses of
hosts or networks:
hostname(config)# no logging names
hostname(config)# show logging
Syslog logging: enabled
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
25-4.
Facility: 16
Timestamp logging: disabled
Standby logging: disabled
Deny Conn when Queue Full: disabled
Console logging: disabled
Monitor logging: disabled
Buffer logging: disabled
Trap logging: level errors, facility 16, 3607 messages logged
Logging to infrastructure 10.1.2.3
History logging: disabled
Device ID: 'inside' interface IP address "10.1.1.1"
Mail logging: disabled
ASDM logging: disabled
Facility: 20
Timestamp logging: enabled
Name logging: disabled
Standby logging: disabled
Configuring and Managing Syslog Messages
"Configuring Log Output
25-3