Interface Naming Convention - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

Interface Naming Convention

The switch support physical and logical interfaces. Interfaces are identified by their type and
the interface number. The physical ports are gigabit interfaces and are numbered on the front
panel. You configure the logical interfaces by using the software. The following table
describes the naming convention for all interfaces available on the switch.
Interface
Physical
Link Aggregation Group (LAG)
CPU Management Interface
30 | Chapter 1: Getting Started
GS108T and GS110TP Smart Switch Software Administration Manual
Description
The physical ports are gigabit Ethernet
interfaces and are numbered sequentially
starting from one.
LAG interfaces are logical interfaces that are
only used for bridging functions.
This is the internal switch interface responsible
for the switch base MAC address. This interface
is not configurable and is always listed in the
MAC Address Table.
Example
g1, g2, g3
l1, l2, l3
LAG1, LAG2
c1