Lacp Port Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

LACP Port Configuration

To display the LACP Port Configuration page, click Switching LAG  Advanced  LACP
Port Configuration.
To configure LACP port priority settings:
Select the check box next to the port to configure. You can select multiple ports to apply
1.
the same setting to all selected ports.
You cannot select ports that are not participating in a LAG.
Note:
Configure the LACP Priority value for the selected port. The field range is 0–255. The
2.
default value is 128.
Configure the administrative LACP Timeout value.
3.
Long. Specifies a long timeout value.
•
Short. Specifies a short timeout value.
•
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
4.
the latest value of the switch.
If you make any changes to this page, click Apply to send the updated configuration to the
5.
switch. Configuration changes take effect immediately.
16 | Chapter 3: Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual