Interface Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

GS108T and GS110TP Smart Switch Software Administration Manual

Interface Configuration

Use the DHCP Filtering Interface Configuration page to view and configure each port as a
trusted or untrusted port. Any DHCP responses received on a trusted port are forwarded. If a
port is configured as untrusted, any DHCP (or BootP) responses received on that port are
discarded.
To access the DHCP Filtering Interface Configuration page, click System Services  DHCP
Filtering  Interface Configuration.
To configure DHCP filtering settings for an interface:
To configure DHCP filtering settings for a physical port, click PORTS.
1.
To configure DHCP filtering settings for a Link Aggregation Group (LAG), click LAGS.
2.
To configure DHCP filtering settings for both physical ports and LAGs, click ALL.
3.
Select the check box next to the port or LAG to configure. You can select multiple ports and
4.
LAGs to apply the same setting to the selected interfaces. Select the check box in the
heading row to apply the same settings to all interfaces.
Choose the trust mode for the selected port(s) or LAG(s).
5.
Enable: Any DHCP responses received on this port are forwarded.
•
Disable: Any DHCP (or BootP) responses received on this port are discarded.
•
Click Apply to apply the change to the system. Configuration changes take effect
6.
immediately.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
7.
the latest value of the switch.
Chapter 2: Configuring System Information | 73