GS108T and GS110TP Smart Switch Software Administration Manual
VLAN Membership Configuration
Use this page to configure VLAN Port Membership for a particular VLAN. You can select the
Group operation through this page.
To display the VLAN Membership Configuration page, click Switching VLAN Advanced
VLAN Membership.
To configure VLAN membership:
From the VLAN ID field, select the VLAN to which you want to add ports.
1.
Click the orange bar below the VLAN Type field to display the physical ports on the switch.
2.
Click the lower orange bar to display the LAGs on the switch.
3.
To select the port(s) or LAG(s) to add to the VLAN, click the square below each port or LAG.
4.
You can add each interface as a tagged (T) or untagged (U) VLAN member.
Tagged: Frames transmitted from this port are tagged with the port VLAN ID.
•
Untagged: Frames transmitted from this port are untagged. Each port can be an
•
untagged member of only one VLAN. By default, all ports are an untagged member of
VLAN 1.
In the following figure, ports g6, g7, and g8 are being added as tagged members to
VLAN 2.
Chapter 3: Configuring Switching Information
| 19