Service Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

Click Cancel to cancel the configuration on the screen and reset the data on the screen to
5.
the latest value of the switch.
If you change any of the settings on the page, click Apply to send the updated configuration
6.
to the switch. Configuration changes take effect immediately.
Click Refresh to refresh the page with the most current data from the switch.
7.

Service Configuration

Use the Service Configuration page to activate a policy on an interface.
To display the page, click QoS  DiffServ  Advanced  Service Configuration.
To configure DiffServ policy settings on an interface:
To configure DiffServ policy settings for a physical port, click PORTS.
1.
To configure DiffServ policy settings for a Link Aggregation Group (LAG), click LAGS.
2.
To configure DiffServ policy settings for both physical ports and LAGs, click ALL.
3.
Select the check box next to the port or LAG to configure. You can select multiple ports and
4.
LAGs to apply the same setting to the selected interfaces. Select the check box in the
heading row to apply the same settings to all interfaces.
To activate a policy for the selected interface(s) select the policy from the Policy In menu,
5.
and then click Apply.
To remove a policy from the selected interface(s) select None from the Policy In menu, and
6.
then click Apply.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
7.
the latest value of the switch.
142 | Chapter 4: Configuring Quality of Service
GS108T and GS110TP Smart Switch Software Administration Manual