Igmp Snooping Querier Vlan Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

IGMP Snooping Querier VLAN Configuration

Use this page to configure IGMP queriers for use with VLANs on the network.
To access this page, click Switching Multicast  IGMP Snooping Querier  Querier VLAN
Configuration.
To configure Querier VLAN settings:
To create a new VLAN ID for IGMP Snooping, select New Entry from the VLAN ID field
1.
and complete the following fields:
VLAN ID. Specifies the VLAN ID for which the IGMP Snooping Querier is to be
•
enabled.
Querier Election Participate Mode. Enable or disable Querier Participate Mode.
•
Disabled. Upon seeing another querier of the same version in the VLAN, the
•
snooping querier moves to the non-querier state.
Enabled. The snooping querier participates in querier election, in which the least
•
IP address operates as the querier in that VLAN. The other querier moves to
non-querier state.
Snooping Querier VLAN Address. Specify the Snooping Querier IP Address to be
•
used as the source address in periodic IGMP queries sent on the specified VLAN.
Click Apply to apply the new settings to the switch. Configuration changes take effect
2.
immediately
To disable Snooping Querier on a VLAN, select the VLAN ID and click Delete.
3.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
4.
the latest value of the switch.
Click Refresh to update the page with the latest information from the switch.
5.
52 | Chapter 3: Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual