DiffServ Example Configuration
To create a DiffServ Class/Policy and attach it to a switch interface, follow these steps:
From the QoS Class Configuration screen, create a new class with the following
1.
settings:
Class Name: Class1
•
Class Type: All
•
For more information about this screen, see
Click the Class1 hyperlink to view the DiffServ Class Configuration screen for this class.
2.
Configure the following settings for Class1:
3.
Protocol Type: UDP
•
Source IP Address: 192.12.1.0
•
Source Mask: 255.255.255.0
•
Source L4 Port: Other, and enter 4567 as the source port value
•
Destination IP Address: 192.12.2.0
•
Destination Mask: 255.255.255.0
•
Destination L4 Port: Other, and enter 4568 as the destination port value
•
For more information about this screen, see
Click Apply.
4.
From the Policy Configuration screen, create a new policy with the following settings:
5.
Policy Selector: Policy1
•
Member Class: Class1
•
For more information about this screen, see
Click Add to add the new policy.
6.
Click the Policy1 hyperlink to view the Policy Class Configuration screen for this policy.
7.
Configure the Policy attributes as follows:
8.
Assign Queue: 3
•
Policy Attribute: Simple Policy
•
Color Mode: Color Blind
•
Committed Rate: 1000000 Kbps
•
Committed Burst Size: 128 KB
•
Confirm Action: Send
•
Violate Action: Drop
•
For more information about this screen, see
From the Service Configuration screen, select the check box next to interfaces g7 and g8 to
9.
attach the policy to these interfaces, and then click Apply (See
page 142).
252 |
Appendix B: Configuration Examples
GS108T and GS110TP Smart Switch Software Administration Manual
Class Configuration
Class Configuration
Policy Configuration
Policy Configuration
on page 135.
on page 135.
on page 138.
on page 138.
Service Configuration
on