Ip Binding Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

GS108T and GS110TP Smart Switch Software Administration Manual

IP Binding Configuration

When an ACL is bound to an interface, all the rules that have been defined are applied to the
selected interface. Use the IP Binding Configuration page to assign ACL lists to ACL
Priorities and Interfaces.
To display the IP Binding Configuration page, click Security  ACL, then click the Advanced
 IP Binding Configuration link.
To configure IP ACL interface bindings:
Select an existing IP ACL from the ACL ID menu.
1.
The packet filtering direction for ACL is Inbound, which means the IP ACL rules are
applied to traffic entering the port.
Specify an optional sequence number to indicate the order of this access list relative to other
2.
access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If the sequence number is not specified by the
user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction will be used. The valid range is 1–4294967295.
Click the appropriate orange bar to expose the available ports or LAGs.
3.
To add the selected ACL to a port or LAG, click the box directly below the port or LAG
•
number so that an X appears in the box.
To remove the selected ACL from a port or LAG, click the box directly below the port
•
or LAG number to clear the selection. An X in the box indicates that the ACL is
applied to the interface.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
4.
the latest value of the switch.
Click Apply to save any changes to the running configuration.
5.
Chapter 5: Managing Device Security | 193