NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual page 85

To configure VLANs:
To add a VLAN, configure the VLAN ID, name, and type, and then click Add.
1.
VLAN ID. Specify the VLAN Identifier for the new VLAN. (You can only enter data in
•
this field when you are creating a new VLAN.) The range of the VLAN ID is 1–4093.
VLAN Name. Use this optional field to specify a name for the VLAN. It can be up to 32
•
alphanumeric characters long, including blanks. The default is blank. VLAN ID 1 is
always named Default.
VLAN Type. This field identifies the type of the VLAN you are configuring. You cannot
•
change the type of the default VLAN (VLAN ID = 1) because the type is always
Default. When you create a VLAN on this page, its type will always be Static.
To delete a VLAN, select the check box next to the VLAN ID and click Delete. You cannot
2.
delete the default VLAN.
To modify settings for a VLAN, select the check box next to the VLAN ID, change the
3.
desired information, and then click Apply. Configuration changes occur immediately.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
4.
the latest value of the switch.
To reset the VLAN settings on the switch to the factory defaults, select the Reset
5.
Configuration check box, and click OK in the popup message to confirm. If the
Management VLAN is set to a non-default VLAN (VLAN 1), it is automatically set to 1 after a
Reset Configuration.
18 | Chapter 3: Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual