Igmp Snooping Vlan Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

GS108T and GS110TP Smart Switch Software Administration Manual
The following table describes the information available on the MFDB Statistics page:
Field
Max MFDB Table Entries
Most MFDB Entries Since
Last Reset
Current Entries
Click Refresh to update the information on the screen with the most current data.

IGMP Snooping VLAN Configuration

Use the IGMP Snooping VLAN Configuration page to configure IGMP snooping settings for
VLANs on the system.
To access the IGMP Snooping VLAN Configuration page, click Switching Multicast  IGMP
Snooping  IGMP Snooping VLAN Configuration.
To configure IGMP snooping settings for VLANs:
To enable IGMP snooping on a VLAN, enter the VLAN ID in the appropriate field and
1.
configure the IGMP Snooping values:
Fast Leave Admin Mode. Enable or disable the IGMP Snooping Fast Leave Mode
•
for the specified VLAN ID. Enabling fast-leave allows the switch to immediately
remove the layer 2 LAN interface from its forwarding table entry upon receiving an
IGMP leave message for that multicast group without first sending out MAC-based
general queries to the interface.You should enable fast-leave admin mode only on
VLANs where only one host is connected to each layer 2 LAN port. This prevents the
Description
Displays the maximum number of entries that the Multicast Forwarding
Database table can hold.
The largest number of entries that have been present in the Multicast
Forwarding Database table since the system was last reset. This value is
also known as the MFDB high-water mark.
Displays the current number of entries in the Multicast Forwarding Database
table.
Chapter 3: Configuring Switching Information | 49