Management Security Settings; Change Password - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

Management Security Settings

From the Management Security Settings page, you can configure the login password,
Remote Authorization Dial-In User Service (RADIUS) settings, Terminal Access Controller
Access Control System (TACACS+) settings, and authentication lists.
To display the page, click the Security  Management Security tab. The Management
Security folder contains links to the following features:
•

Change Password

• RADIUS Configuration
• Configuring TACACS+
• Authentication List Configuration
Change Password
Use the page to change the login password. To display the page, click Security 
Management Security  User Configuration  Change Password.
To change the login password for the management interface:
Specify the current password in the Old Password. The entered password will be
1.
displayed in asterisks (*). Passwords are 1–20 alphanumeric characters in length and
are case sensitive.
Enter the new password. It will not display as it is typed, and only asterisks (*) will show on
2.
the screen. Passwords are 1–20 alphanumeric characters in length and are case sensitive.
To confirm the password, enter it again to make sure you entered it correctly. This field will
3.
not display, but will show asterisks (*).
Use the Reset Password field to reset the password to the default value.
4.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
5.
the latest value of the switch.
146 | Chapter 5: Managing Device Security
GS108T and GS110TP Smart Switch Software Administration Manual
on page 146
on page 147
on page 153
on page 155