Trap Logs - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

Trap Logs

Use the Trap Logs page to view information about the SNMP traps generated on the switch.
To access the Trap Logs page, click the Monitoring  Logs tab, and then click the Trap
Logs link.
The following table describes the Trap Log information displayed on the screen.
Field
Number of Traps Since
Last Reset
Trap Log Capacity
Number of Traps Since
Log Last Viewed
The page also displays information about the traps that were sent.
Field
Log
System Up Time
Trap
214 | Chapter 6: Monitoring the System
GS108T and GS110TP Smart Switch Software Administration Manual
Description
The number of traps that have occurred since the switch last reboot.
The maximum number of traps stored in the log. If the number of traps exceeds the
capacity, the entries will overwrite the oldest entries.
The number of traps that have occurred since the traps were last displayed.
Displaying the traps by any method (such as terminal interface display, Web
display, or upload file from switch) will cause this counter to be cleared to 0.
Description
The sequence number of this trap.
The time at which this trap occurred, expressed in days, hours, minutes, and
seconds since the last reboot of the switch.
Information identifying the trap.