Cos Interface Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

CoS Interface Configuration

Use the CoS Interface Configuration page to apply an interface shaping rate to all interfaces
or to a specific interface.
To display the CoS Interface Configuration page, click the QoS  CoS tab, and then click the
Advanced  CoS Interface Configuration link.
To configure CoS settings for an interface:
To configure CoS settings for a physical port, click PORTS.
1.
To configure CoS settings for a Link Aggregation Group (LAG), click LAGS.
2.
To configure CoS settings for both physical ports and LAGs, click ALL.
3.
Select the check box next to the port or LAG to configure. You can select multiple ports and
4.
LAGs to apply the same setting to the selected interfaces.
From the Interface Trust Mode field, specify whether or not the selected interface(s) trust a
5.
particular packet marking when the packet enters the port.
Untrusted. Do not trust any CoS packet marking at ingress.
•
802.1p. The eight priority tags that are specified in IEEE 802.1p are p0 to p7. The
•
QoS setting lets you map each of the eight priority levels to one of four internal
hardware priority queues: High, Normal, Low, and Lowest.
DSCP. The six most significant bits of the DiffServ field are called the Differentiated
•
Services Code Point (DSCP) bits.
128 | Chapter 4: Configuring Quality of Service
GS108T and GS110TP Smart Switch Software Administration Manual