Speed All; Monitor Session - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Acceptable values are:
100h
100f
10h
10f

4.1.12 speed all

This command sets the speed and duplex setting for all interfaces.
Format
Mode
Acceptable values are:
100h
100f
10h
10f

4.1.13 monitor session

This command configures a probe port and a monitored port for monitor session (port
monitoring). To enable port monitoring, you must add a source interface, destination
interface, and enable the mode. If enabled, the probe port monitors all the traffic received
and transmitted on the physical monitored port.
Format
Mode
4.1.13.1 no monitor session
This command removes the monitor session (port monitoring) designation from the source
probe port, the destination monitored port and all VLANs. Once the port is removed from
the VLAN, the user must manually add the port to any desired VLANs.
Note: This command sets the monitor session (port monitoring) mode to disable
4-6
100BASE-T half duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
speed all {<100 | 10> <half-duplex | full-duplex>}
Global Config
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
monitor session <session-id> {source interface
<slot/port> | destination interface <slot/port> |
mode}
Global Config
and removes the source and destination interfaces.
v1.0, February 2007
Port and System Setup Commands