Ip Domain-Lookup; Ip Domain-Name; Ip Name-Server - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

4.5.1 ip domain-lookup

To enable the IP Domain Naming System (DNS)-based host name-to-address translation,
use the ip domain-lookup global configuration command. To disable the DNS, use the no
form of this command
Format
Mode
Default

4.5.2 ip domain-name

To define a default domain name (<name>) that the software uses to complete unqualified
host names (names without a dotted-decimal domain name), use the ip domain-name
global configuration command. To remove default domain name, use the no form of this
command.
Default domain used to complete unqualified host names. Do not include the initial period
that separates an unqualified name from the domain name.
<name> is a string of 1 to 255 characters.
Format
Mode

4.5.3 ip name-server

To set the available name servers, use the ip name-server global configuration command.
<server-address> is IP addresses of the name server. Up to 8 servers can be defined in one
command, or by using multiple commands. The preference of the servers is determined by
the order they were entered. To remove a name server, use the no form of this command.
Format
Mode
4-26
[no] ip domain-lookup
Global Config
enabled
name
ip domain-name
no ip domain-name
Global Config
[no] ip name-server
server-address8]
Global Config
v1.0, February 2007
server-address1 [server-address2 ...
Port and System Setup Commands