Show Interfaces Cos-Queue - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Untrusted Traffic
Class

14.1.12 show interfaces cos-queue

This command displays the class-of-service queue configuration for the specified
interface. The unit/slot/port parameter is optional and is only valid on platforms that
support independent per-port class of service mappings. If specified, the class-of-service
queue configuration of the interface is displayed. If omitted, the most recent global
configuration settings are displayed.
Format
Mode
Queue Id
Minimum
Bandwidth
Scheduler Type
Queue
Management Type
If you specify the interface, the following information also appears:
Interface
Interface Shaping
Rate
Quality of Service (QoS) Commands
The traffic class used for all untrusted traffic. This is only dis-
played when the COS trust mode is set to 'untrusted'.
show interfaces cos-queue [unit/slot/port]
Privileged EXEC
An interface supports n queues numbered 0 to (n-1). The spe-
cific n value is platform dependent.
The minimum transmission bandwidth guarantee for the
queue, expressed as a percentage. A value of 0 means band-
width is not guaranteed and the queue operates using best-
effort. This is a configured value.
Indicates whether this queue is scheduled for transmission
using a strict priority or a weighted scheme. This is a config-
ured value.
The queue depth management technique used for this queue
(tail drop).
This displays the unit/slot/port of the interface. If displaying
the global configuration, this output line is replaced with a
Global Config indication.
The maximum transmission bandwidth limit for the interface
as a whole. It is independent of any per-queue maximum
bandwidth value(s) in effect for the interface. This is a con-
figured value.
v1.0, February 2007
14-7