Show Mac-Address-Table Static - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Interfaces
Forwarding
Interfaces

4.4.11 show mac-address-table static

This command displays the Static MAC Filtering information for all Static MAC Filters. If
you select
<all>
value for
<macaddr>,
Static MAC Filter information only for that MAC address and VLAN.
Format
Mode
MAC Address
VLAN ID
Source Port(s)
Destination
Port(s)
Port and System Setup Commands
The list of interfaces that are designated for forwarding
(Fwd:) and filtering (Flt:).
The resultant forwarding list is derived from combining all
the component's forwarding interfaces and removing the
interfaces that are listed as the static filtering interfaces.
, all the Static MAC Filters in the system are displayed. If you supply a
you must also enter a value for
show mac-address-table static {<macaddr> <vlanid>
| all}
Privileged EXEC
Is the MAC Address of the static MAC filter entry.
Is the VLAN ID of the static MAC filter entry.
Indicates the source port filter set's slot and port(s).
Indicates the destination port filter set's slot and port(s).
v1.0, February 2007
, and the system displays
<vlanid>
4-23