Show Policy-Map (Gsm7248 Only) - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Service Table
Max

14.6.3 show policy-map (GSM7248 only)

This command displays all configuration information for the specified policy. The
<policyname>
Format
Mode
If the Policy Name is specified the following fields are displayed:
Policy Name
Type
The following information is repeated for each class associated with this policy (only
those policy attributes actually configured are displayed):
Assign Queue
Class Name
Committed Burst
Size (KB)
Committed Rate
(Kbps)
Conform Action
Conform COS
Conform DSCP
Value
Quality of Service (QoS) Commands
The maximum allowed entries (rows) for the Service Table.
is the name of an existing DiffServ policy.
show policy-map [policyname]
Privileged EXEC
The name of this policy.
The policy type (Only inbound policy definitions are sup-
ported for this platform.)
Directs traffic stream to the specified QoS queue. This
allows a traffic classifier to specify which one of the sup-
ported hardware queues are used for handling packets
belonging to the class.
The name of this class.
This field displays the committed burst size, used in simple
policing.
This field displays the committed rate, used in simple polic-
ing,
The current setting for the action taken on a packet consid-
ered to conform to the policing parameters. This is not dis-
played if policing is not in use for the class under this policy.
This field shows the CoS mark value if the conform action is
set-cos-transmit.
This field shows the DSCP mark value if the conform action
is set-dscp-transmit.
v1.0, February 2007
14-27