Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
6.1.19 protocol vlan group
This command adds the physical interface to the protocol-based VLAN identified by
. You can associate multiple interfaces with a group, but you can only associate
<groupid>
each interface and protocol combination with one group. If adding an interface to a group
causes any conflicts with protocols currently associated with the group, this command
fails and the interface(s) are not added to the group.
Create the referenced VLAN before you create the protocol-based VLAN except when
you configure GVRP to create the VLAN.
Format
Mode
6.1.19.1 no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is
identified by this
Format
Mode
6.1.20 protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by
. You can associate multiple interfaces with a group, but you can only associate
<groupid>
each interface and protocol combination with one group. If adding an interface to a group
causes any conflicts with protocols currently associated with the group, this command will
fail and the interface(s) will not be added to the group.
Create the referenced VLAN before you create the protocol-based VLAN except when
you configure GVRP to create the VLAN.
Format
Mode
6.1.20.1 no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is
identified by this
Format
Mode
VLAN Commands
protocol vlan group <groupid>
Interface Config
.
<groupid>
no protocol vlan group <groupid>
Interface Config
protocol vlan group all <groupid>
Global Config
.
<groupid>
no protocol vlan group all <groupid>
Global Config
v1.0, February 2007
6-9