Interface Range; Interface Vlan; Interface Lag; Cablestatus - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

4.1.2 interface range

This command gives you access to a range of port interfaces, allowing the same port
configuration to be applied to a set of ports.
Format
Mode

4.1.3 interface vlan

This command gives you access to to the vlan virtual interface mode, which allows certain
port configurations (for example, the IP address) to be applied to the VLAN interface.
Type a question mark (?) after entering the interface configuration mode to see the
available options.
Format
Mode

4.1.4 interface lag

This command gives you access to the LAG (link aggregation, or port channel) virtual
interface, which allows certain port configurations to be applied to the LAG interface.
Type a question mark (?) after entering the interface configuration mode to see the
available options.
Note: The IP address cannot be assigned to a LAG virtual interface. The interface
Format
Mode

4.1.5 cablestatus

This command tests the status of the cable attached to an interface.
Format
Mode
4-2
interface range <slot/port>-<slot/port>
Global Config
interface vlan <vlan id>
Global Config
must be put under a VLAN group and an IP address assigned to the VLAN
group.
interface lag <lag id>
Global Config
cablestatus <slot/port>
Privileged EXEC
v1.0, February 2007
Port and System Setup Commands