Chapter 3
Installing the Cisco 10008 Router
Auxiliary Modem Connection
This asynchronous EIA/TIA-232 serial port is used to connect a modem to the PRE for remote
administrative access. Use the following procedure to connect the Cisco 10008 router to a modem.
Figure 3-35
Connect one end of the modem cable to the RJ-45 port on the primary PRE, labeled AUX
Step 1
Run the cable up and through the cable management bracket and connect the other end of the cable to
Step 2
your modem.
Data Network Cable Connections
For data network cable connection installation information, SFP and GBIC information, cable
specifications and optical specifications, see the
Installation
If you have completed all cable connections, go to
Chapter 4, "Starting and Configuring the Router."
OL-0659-13
Connecting Modem Cable to Auxiliary Port
C IS C O
1 0 0 0 0
Guide.
Connecting Network Management and Signal System Cables
Cisco 10000 Series Routers Line Card Hardware
the"Powering On the System" section on page
Cisco 10008 Router Hardware Installation Guide
(Figure
3-35).
4-1,
3-35