Cisco 10008 Hardware Installation Manual page 54

Non-Rack Installation
When installing the Cisco 10008 router on a workbench or tabletop, ensure that the surface is clean and
that you have considered the following:
The Cisco 10008 router requires at least 3 inches (7.62 cm) of clearance at the inlet and exhaust
•
vents (the front and top/rear sides of the chassis).
The Cisco 10008 router should be installed off the floor. Dust that accumulates on the floor is drawn
•
into the interior of the router by the cooling fans. Excessive dust inside the router can cause
overtemperature conditions and component failures.
• There must be approximately 19 inches (48.3 cm) of clearance at the front and rear of the chassis to
install and replace FRUs, or to access network cables and equipment.
• The Cisco 10008 router needs adequate ventilation. Do not install it in an enclosed cabinet where
ventilation is inadequate.
• Have the cable-management bracket available if you plan to install it on the front of the chassis.
An adequate chassis ground (earth) connection exists for your router chassis (see the
•
the Chassis to Ground" section on page
• Always follow proper lifting practices as outlined in the
when handling the chassis.
Use the following procedure to install the Cisco 10008 router on a tabletop or equipment shelf:
Remove any debris and dust from the tabletop or equipment shelf, as well as the surrounding area.
Step 1
Step 2 Lift the chassis into position on the tabletop or equipment shelf.
Warning Two people are required to lift the chassis. To prevent injury, keep your back straight and lift with
your legs, not your back. Statement 164
Figure 3-10
Cisco 10008 Router Hardware Installation Guide
3-12
Lifting the Chassis
FANS
FAN
OK MULTI-
FAILUR E
FAN
FAILUR
E CAUT ION
When hot
remov al swapp ing
be done and replac this fan tray,
system in under ement must
shutdo wn will two minute s or
occur.
1
2
3
4
0A
PRO CES
CISCO SOR ONL 0B
10000 CISCO
CISCO Y 5
10000 6
10000 CISCO
10000 7
CISCO 8
10000
CISCO
10000
CISCO
CISCO
10000
10000 CISCO
10000 CISCO
10000
POW ER
FAUL T
MISW IRE
POW ER
FAUL T
MISW IRE
PRO CES
SOR ONL
Y
Chapter 3
3-13).
"Electrical Safety" section on page
Installing the Cisco 10008 Router
"Connecting
2-13,
OL-0659-13