Removing And Replacing The Pre - Cisco 10008 Hardware Installation Manual

Connecting Alarm Indicators
Figure 5-38
Secure the power cabling to the chassis by feeding a tie wrap through the slot on the side of the chassis
Step 7
and binding the cables (see blowout in
Replace the rear safety cover, making sure that the alarm indicator wires exit through the holes on the
Step 8
side of the cover

Removing and Replacing the PRE

Use the following procedure to install or to remove and replace a PRE module.
Do not operate the system unless all slots contain a line card or a blank faceplate. Blank faceplates are
Caution
necessary in empty slots to prevent exposure to hazardous voltages, to reduce electromagnetic
interference (EMI) that may disrupt other equipment, and to direct the flow of cooling air through the
chassis.
Cisco 10008 Router Hardware Installation Guide
5-36
Alarm Indicator Wires Exiting Safety Cover
Figure
(Figure 5-38).
Chapter 5
5-38).
Maintaining the Cisco 10008 Router
OL-0659-13