Connecting The Chassis To Ground - Cisco 10008 Hardware Installation Manual

Chapter 3 Installing the Cisco 10008 Router
Note
Figure 3-11
Step 3 Attach the cable management bracket to the bottom of the chassis if you are using it
Step 4 Check that all
Go to the
Step 5

Connecting the Chassis to Ground

Connecting the Cisco 10008 chassis to earth ground is required for all DC powered installations, and any
AC powered installation where compliance with Telcordia (formerly Bellcore) grounding requirements
is necessary. Have the recommended tools and supplies available before you begin this procedure (see
Table
Warning Never defeat the ground conductor or operate the equipment in the absence of a suitably installed
ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are
uncertain that suitable grounding is available. Statement 93
OL-0659-13
The cable management bracket consists of two pieces (the cable guide and channel), and is
shipped assembled. If you want to use the cable guide only, you can remove the channel by
loosening the captive screws before attaching the cable guide to the chassis.
Attaching Cable Management Bracket
FAN S
OK FAN
FAI LUR MU LTI-
E
FAN
FAI LUR
E
1
2
3
CIS CO
100 00 CIS CO
100 00 CIS CO
100 00
PO WE R
FA UL T
MI SW IRE
PO WE R
FA UL T
MI SW IRE
Ejector levers are in the closed position.
–
PRE and line card captive screws are tight.
–
"Connecting the Chassis to Ground" section on page 3-13
3-1).
CA UTI
Wh en hot ON
rem ova swa ppin
g this fan
l and rep
be don lace me tray ,
e in und nt mu st
sys tem er two
shu tdo min ute
wn will s or
occ ur.
4
0A
PR OC
ES SO R 0B
ON LY
5
CIS CO 6
7
100 00 CIS CO
8
100 00
CIS CO
100 00
CIS CO
CIS CO
100 00
CIS CO
100 00
CIS CO
100 00
100 00
PR OC
ES SO R
ON LY
Cisco 10008 Router Hardware Installation Guide

Connecting the Chassis to Ground

(Figure 3-11).
to continue the installation.
3-13