Connector Ports - Cisco 10008 Hardware Installation Manual

Chapter 1 Cisco 10008 Router Overview
Each PXF ASIC has 32 independent processors that work on per-packet feature processing, yielding
high throughput while still allowing substantial feature processing. The PXF centralizes packet
processing in the PRE, which frees up space on line cards, enabling high interface density, yet retaining
a compact form factor.
Although the PRE module supports hot-swapping, one PRE is required for the system to operate.
Caution
Hot-swapping a non-redundant PRE results in a system outage stopping all traffic. A PRE in a redundant
configuration can be hot-swapped without having an impact on system operation.
Figure 1-6
Figure 1-6
Figure 1-7
Figure 1-7
Figure 1-8
Figure 1-8

Connector Ports

The front panel on the PRE contains three ports with RJ-45 connectors (see
•
•
•
OL-0659-13
shows the front panel of the Performance Routing Engine, product number ESR- PRE.
Performance Routing Engine, Product Number ESR-PRE, Front Panel
shows the front panel of the Performance Routing Engine, product number ESR-PRE1.
Performance Routing Engine, Product Number ESR-PRE1, Front Pane
shows the front panel of the Performance Routing Engine, product number ESR-PRE2.
Performance Routing Engine, Product Number ESR-PRE2, Front Panel
Console port (CON)—This asynchronous EIA/TIA-232 serial port is used to connect a terminal to
the PRE for local administrative access.
Auxiliary port (AUX)—This asynchronous EIA/TIA-232 serial port is used to connect a modem to
the PRE for remote administrative access.
Ethernet port (ETH)—This Ethernet port is used to connect the PRE to a 10/100BASE-T network
management LAN.
Cisco 10008 Router Hardware Description
PERFORMANCE ROUTING ENGINE
PERFORMANCE ROUTING ENGINE
Figure
Cisco 10008 Router Hardware Installation Guide
PERFORMANCE ROUTING ENGINE
ESR-PRE1
ESR-PRE2
1-6):
1-9