Required Tools And Equipment; Verifying Contents After Unpacking - Cisco 10008 Hardware Installation Manual

Required Tools and Equipment

With the other hand, grasp the top rear of the chassis under the air exhaust and carefully lift the chassis
Step 2
as shown in

Required Tools and Equipment

The tools and equipment listed below are recommended as the minimum necessary to install the
Cisco 10008 router. You may need additional tools and equipment to install associated equipment and
cables. You may also require test equipment to check electronic and optical signal levels, power levels,
and communications links.
•
•
•
•
•
•
•
Refer to the
requirements to connect the chassis to ground.

Verifying Contents After Unpacking

Power cables, manuals, and other additional items are packaged in separate boxes. After you have
unpacked the system to verify that you have received all of the required components. Using the packing
list as a guide, take the following steps to check the contents of the Cisco 10008 router shipping
container:
Check the contents of the boxes containing accessory items. Verify that you have received all equipment
Step 1
listed in your order, including the following:
•
•
Check that all line cards you ordered are installed in the chassis (including PCMCIA flash cards installed
Step 2
in the PRE). Ensure that the configuration matches the packing list.
Cisco 10008 Router Hardware Installation Guide
2-16
Figure 2-4.
Number 2 Phillips screwdriver
A 3/16-inch flat-blade screwdriver
A 1/4-inch flat-blade screw driver
Antistatic mat or antistatic foam
An electrostatic discharge (ESD) grounding strap or the disposable ESD strap shipped with the
system
Tape measure (optional)
Level (optional)
"Connecting the Chassis to Ground" section on page 3-13
System hardware and software documentation
Any optional equipment that you ordered, such as transceivers (GBICs), flash cards, cables, or
special connectors
Chapter 2 Preparing for Installation
for specific tool and equipment
OL-0659-13