Cisco 10008 Hardware Installation Manual page 134

Chapter 5 Maintaining the Cisco 10008 Router
Connecting Alarm Indicators
Figure 5-44 Closing the Ejector Levers
PR O C
ES SO R
O N LY
P R O C
E S S O R
O N L Y
Simultaneously pivot both ejector levers toward each other (until they are parallel to the faceplate) to
Step 10
firmly seat the PRE in the backplane (Figure 5-44).
The PRE cycles through its power-on self-test. The Fail LED stays on briefly (about 5 to 6 seconds) and
then shuts off. If the Fail LED remains on or is flashing, go to the "Troubleshooting Installation
Problems" section on page 4-12.
Cisco 10008 Router Hardware Installation Guide
5-42
OL-0659-13