Cisco 10008 Hardware Installation Manual page 46

Rack-Mounting the Chassis
(Optional) Install a shelf in the rack to support the Cisco 10008 chassis. If you use a shelf, you can
Step 1
perform the installation with only two people.
(Optional) Remove the blower module and the PEMs to make the chassis easier to lift.
Step 2
Lift the chassis into position between the rack posts (requires two people).
Step 3
Align the mounting bracket holes with the rack post holes
Step 4
(performed by the third person unless the chassis is resting on a shelf).
Figure 3-2
Attach the cable management bracket to the bottom of the chassis
Step 5
Note
Step 6 Check that all
–
–
–
Go to the
Step 7
Cisco 10008 Router Hardware Installation Guide
3-4
Attaching Cable Management Bracket
FAN S
OK FAN
FAI LUR MU LTI-
E
FAN
FAI LUR
E
Wh en hot
rem ova
be don
sys tem
1
2
3
4
CIS CO
100 00 CIS CO
CIS CO
100 00
CIS CO
100 00
100 00
PO WE R
FA UL T
MI SW IRE
PO WE R
FA UL T
MI SW IRE
The cable management bracket consists of two pieces (the cable guide and channel), and is
shipped assembled. If you want to use the cable guide only, you can remove the channel by
loosening the captive screws before attaching the cable guide to the chassis.
Ejector levers are in the closed position.
Chassis mounting screws are tight.
PRE and line card captive screws are tight.
"Connecting the Chassis to Ground" section on page 3-13
(Figure
CA UT ION
swa ppi
ng this
l and rep fan tray
lace me
e in und nt mu st ,
er two
shu tdo min ute
wn will s or
occ ur.
0A
PR OC
ES SO R 0B
ON LY
5
6
7
CIS CO
8
100 00 CIS CO
100 00
CIS CO
CIS CO
100 00
100 00 CIS CO
100 00 CIS CO
100 00
PR OC
ES SO R
ON LY
Chapter 3 Installing the Cisco 10008 Router
3-1) and attach the chassis to the rack
(Figure 3-2).
to continue the installation.
OL-0659-13