Chapter 3
Installing the Cisco 10008 Router
Figure 3-31
Connect one end of the RJ-45 crossover cable to the serial RJ-45 port (CON) on the PRE module
Step 1
(Figure
Run the cable up and through the cable management bracket and connect the other end of the RJ-45
Step 2
crossover cable to the RJ-45 adapter
DB-25 serial connector, use the RJ-45-to-DB-25 adapter.
•
DB-9 serial connector, use the RJ-45-to-DB-9 adapter.
•
Figure 3-32
Step 3
Connect the adapter to your video terminal to complete the cable connection.
Power on your video terminal.
Step 4
Configure your video terminal to match the following default console port settings:
Step 5
9600 baud
•
8 data bits
•
No parity generation or checking
•
1 stop bit
•
•
No flow control
OL-0659-13
Console Port Connection on the PRE Module
C IS C O
1 0 0 0 0
3-31).
Connecting an RJ-45-to-DB-9 Console Cable Adapter
Connecting a Video Terminal to the PRE Console Port
(Figure
3-32). If your terminal is equipped with a:
Cisco 10008 Router Hardware Installation Guide
3-31