Cisco 10008 Router Features - Cisco 10008 Hardware Installation Manual

Cisco 10008 Router Features

Performance routing engine redundancy in the Cisco 10008 router is achieved through an
implementation of Enhanced High System Availability (EHSA). This feature lets you configure the
chassis for non-redundant operation with one PRE, or for redundant operation with two PREs.
In addition to PRE redundancy, SONET/SDH line cards can be configured for
1+1 Automatic Protection Switching (APS) to accommodate failure of either a line card or the
transmission facility carrying trunk traffic to upstream equipment.
The Cisco 10008 router is designed to scale to unprecedented levels with plans to further increase
scalability in future releases. The current release provides support for up to:
•
•
•
For CT3 line cards, this equates to:
•
For channelized OC-12 line cards, this equates to:
•
Cisco 10008 Router Features
The Cisco 10008 router and power subsystem support the following key features:
•
•
•
•
•
•
•
Cisco 10008 Router Hardware Installation Guide
1-2
1300 PPP sessions
4200 Frame Relay sessions
300 Border Gateway Protocol (BGP) peers
1176 T1 connections per chassis or up to 3900 T1 connections per 7-foot rack.
2352 T1 connections per chassis or up to 7056 T1 connections per 7-foot rack.
19-inch rack mount, 12-inch depth
21.75-inch height (3 units per 7-foot rack)
Dual –48 VDC or 100 to 240 VAC redundant hot swappable PEMs
10 slots total, 2 central slots for PREs and 8 interface card slots
Multiple fans in blower module provide redundancy to support single failure, and blower
replacement will not interrupt service (within certain time limits)
Brackets for cable management
Alarm relays; minor, major, and critical
Chapter 1 Cisco 10008 Router Overview
OL-0659-13