Cisco Prisma II Installation And Operation Manual page 80

Configuring the Reverse Receiver
Introduction
Using LCI, you can configure the parameters listed below.
Configurable Parameters
Configurable parameters for the Prisma II Reverse Receiver are listed below.
Control Function
Rx 1 Mute Force Mute. Muting of the RF signal and
Switch, removal of power to the amplifier only if the
Enable control is on for this particular side.
Rx 2 Mute
Switch
Rx 1 Receiver Enables or disables unit operation, i.e.,
Enable, muting enabled and no alarm capability.
Rx2 Receiver
Enable
Rx 1 Manual Force Alarm. Alarm relay is manually
Alarm
overridden only if the Enable control is On.
This sets a particular side to alarm as if there
Rx 2 Manual
was an internal alarm, i.e., Alarm output
Alarm
high, muting on as per Force Mute above
Rx 1 Master Configures the module as master or slave. If
Select set to Master, the unit is controlled only by
the Enable control above. If set to Slave, the
Rx 2 Master
unit is controlled by a combination of the
Select
Enable control and the external input
CNT_IN_1 or CNT_IN_2.
Rx 1 Sets the attenuation level of the output RF
Attenuator signal.
Rx 2
Attenuator
4-22 Operation Using LCI
Values Default
On = Mute On Off
Off = Mute Off
On = Enabled On
Off = Disabled
On = Alarm On Off
Off = Alarm Off
On = Master On On
Off = Slave On
Decimal number 0
between 0 and 20
dB, increments of
0.5 dB
78-713378-01 Rev C