Cisco Prisma II Installation And Operation Manual page 25

Reverse video receiver and reverse data receiver

Hide thumbs Also See for Prisma II:

Installing the Module in the Chassis,

Gently slide the module into the chassis until you feel the connectors on the

back of the module join the receptacles at the back of the slot. Use the module

ejector to lock the module in place.

Note: Do not force or bang the module into the chassis. If properly aligned, it

will slide in with minimal force.

Secure the module by pressing the two ejectors located on the left side of the

module until they lock. When the levers are locked, the power and

communications connections at the rear of the module mates with the

communications connectors at the back of the chassis slot.

Hand-tighten the screw at the top of the module, to secure it in the chassis.

Use a

2-8

-in. flat-blade screwdriver to secure. Do not over tighten.

Installation

Continued

78-713378-01 Rev C