Cisco Prisma II Installation And Operation Manual page 27

Reverse video receiver and reverse data receiver

Hide thumbs Also See for Prisma II:

Connecting Optical Cables,

Using the Fiber Fish to Pull the Optical Cable to the Prisma II Module

To get an optical cable to the module follow these procedures.

Insert the Fiber Fish tool through the slot located just above the bottom of the

chassis.

At the rear of the chassis, locate the appropriate optical cable.

Insert the optical cable into notched area of Fiber Fish tool as shown.

At the front of the chassis, pull the Fiber Fish tool (with cable attached) to the

front of the chassis.

Disengage the optical cable from the Fiber Fish tool and attach to the

appropriate connector on desired module. See Cable Connection Procedure.

2-10

Continued

Installation

78-713378-01 Rev C