Cisco Prisma II Installation And Operation Manual page 23

Connecting the RF Cables to the Chassis
RF Cable Connection Procedure
Important: This procedure assumes the Prisma II Chassis is mounted in a rack.
Follow this procedure to make the RF connections for each module to be installed.
1. At the front/rear of the Prisma II Chassis, locate the RF ports.
Note: RF Ports are located on the front of front access chassis.
2. Attach an RF cable to the Port A connector (RF output) of the corresponding
slot where the module is to be installed. This is the RF output connection.
3. Route the RF cable from Port A to the appropriate RF destination.
4. Connect another RF cable to Port B (RF output) of the slot where the module
is installed. Hand-tighten the connector.
5. Route the RF cable from Port B to the appropriate RF destination.
6. If F-connectors are installed, use a 7/16-in. open-end wrench to secure both
cables to the connectors at the chassis.
2-6 Installation 78-713378-01 Rev C