Cisco Prisma II Installation And Operation Manual page 67

Reverse video receiver and reverse data receiver

Hide thumbs Also See for Prisma II:

Connecting Your Laptop Computer to the Chassis

Introduction

Before you start LCI, you must first connect your laptop computer to the chassis that

contains the module(s) you want to check.

Important: LCI communicates only with those modules located in the chassis your

computer is attached to. To check other modules, you must connect your computer

to the chassis they are located in.

Connecting to the Chassis

To connect your laptop to the chassis, follow these steps.

Plug one end of a nine-pin serial extension cable into your computer.

Plug the other end of the cable into the LCI port. This port is labeled "Local

Craft Interface".

78-713378-01 Rev C

Operation Using LCI

4-9