Cisco Prisma II Installation And Operation Manual page 16

Reverse video receiver and reverse data receiver

Hide thumbs Also See for Prisma II:

The Back Panel

Back Panel Connectors

Blind-mate connectors make it easy to install this module. The connector on the back

of the module mates with a connector on the inside of the chassis. The 110-pin

connector provides the following:

Electrical power input

•

Alarm communications

•

Status-monitoring connections

•

Communications and control connections

•

Power and Communications Connector

The power and communications connector on the back of the module mates with a

connector inside of the chassis, and supplies power from the chassis to the

transmitter. The 110-pin connector also routes alarm and status-monitoring

information from the receiver to the Prisma II Chassis.

1-6

Introduction

78-713378-01 Rev C