Cisco Prisma II Installation And Operation Manual page 24

Installing the Module in the Chassis
Installing the Module
Important: The following procedure assumes the Prisma II chassis is mounted in a
rack. This procedure applies to both chassis styles.
To install the module in the chassis, follow these steps.
1. Locate the fiber guides at the bottom of the chassis and the module guide
slots inside the chassis as shown in the following illustration.
2. Align the ridges on the top and bottom of the module with the module guide
slots located on the chassis. Module ejectors must be fully extended when
inserting the module.
78-713378-01 Rev C Installation 2-7