Cisco Prisma II Installation And Operation Manual page 49

Configuring the Reverse Receiver Using the ICIM,
Configuring Parameters
Using the ICIM, you can configure the parameters listed above. To configure the
parameters, follow these steps. CONFIG parameters are listed before these
procedures.
1.
From the MAIN menu, press the
fields.
2.
Press the
the
3.
Press the
4.
Press the
slot.
5.
Press the
displayed on the ICIM menu.
6.
To configure the module, press the
7.
Press the
until you find the parameter of interest.
8.
Press the
9.
Press the
selected control.
10.
Press the
78-713378-01 Rev C
key to address the Shelf number. Then press the
SEL
key to scroll to the number of the desired shelf.

key. The Slot field is highlighted.
ENTER
key or the

key. The initial information for the module of interest is now
ENTER
key or the

key to select the highlighted control.
SEL
key or the

key to save the changes and return to the MAIN menu.
ENTER
Operation Using the ICIM
Continued
key to highlight the Shelf and Slot

keys to scroll to the number of the desired

key.
CFG
key to scroll through the configurable controls

key to activate or change the value of the

key or

Continued on next page
3-17